The funny green laser.

プロフィール写真

lasereshopさん


0

7月のカレンダー

1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31

各月のペット日記

lasereshop さんのペット日記

The funny green laser.
2016年07月04日 19:25
ペットカテゴリ : 猫 > コビー > バーミーズ

I have purchased a number of great Laser Pointer from lasereshop, so it was no surprise that this combination Green

Laser Sight/Illuminator was a well built piece of equipment when I inspected it upon arrival. It is a fairly large

item, measuring right at 6" long, so you will need a good amount of rail space on the firearm that you attach it to,

and a minimum of four rail slots. I attached mine to a Hi-Point 995TS Carbine, and it tightened down nice and solid.

Just make sure that you leave enough room at the rear to be able to access the push button, or to screw the cap off

to put a fresh battery in, without first having to remove the unit from your rail.
http://www.lasereshop.com/green-laserpointer/p-25.html

Pros:
The high powered laser is very intense and works equally well as a Sight Designator and Illuminator. As stated in

the listing, no battery is included, so you will need to pick up a CR123A battery. I purchased two rechargeables by

the brand name Earthshine, and used the included battery charger to charge them. The charger worked great. This is a

high drain item, so rechargeable batteries are the way to go. You can focus the green beam from pinpoint, all the

way up to a flashlight sized beam. The beam is easily seen in full daylight, and is very bright in the dark of

night. I was able to illuminate a house on the next street over, nearly 100 hundred yards away with no problem. The

green light is much less harsh than your typical white LED white light. You don't get the typical splash out of

white light side to side like with a typical flashlight, but it illuminates very nicely just what is within the

confines of the green beam.
http://www.lasereshop.com/green-laserpointer/p-27.html
The pressure switch that comes with this 200mw green laser actually works... that too is a nice change. However, you

need to do a bit of work first, before you can use it; the sight only comes with one end cap, so you have to gently

punch the push-button actuator out of the end cap, and then replace it with the pressure cap's actuator. I used the

round end of a metal punch and gently tapped the push-button free with light taps of a small hammer on the punch...

only took a couple taps. The pressure switch's actuator sits loosely in the cap, but seats nicely once you tighten

the cap down on the unit (with battery installed).
http://www.lasereshop.com/green-laserpointer/p-4.html
Since I already have a pressure switch on my vertical grip (fingertip actuated), I spliced this Red Laser pressure

switch's wiring (removed the entire length of the coiled section) to my existing wiring, and applied liquid

electrical tape to seal the deal. My wiring runs through the quad rail and to the pressure switch on the grip -- and

it works perfectly. Nice clean look and feel without all that extra coiled wiring around red laser.
http://www.lasereshop.com/red-laserpointer/p-22.html
Since the elevation and windage turrets are finger controlled, zeroing at 25 yards took all of 2 minutes. Fantastic.

No slippage so far.

As a general condition comment -- the red laserI received was brand new, well packed, shipped quickly, and each part

inside of the retail carton has its own little section surrounded by foam that kept our unit safe during transit.

Nice done.

http://www.kodaisi.com/?m=pc&a=page_fh_diary&target_c_dia...
http://imagenes.in/?p=116336

コメントを書く

コメントを書くにはログインが必要です。

PC版で見る